Yes, the RV Cabinet Catch and Strikes # 37270485 will work on a drawer. This latch is primarily used with cabinet doors, however I don't see any reason why you couldn't use it with a drawer.
This kit also includes 5/8", 3/4", 7/8", and 1" deep strikes to fit a wide variety of applications.
Attached is a product overview video for you to check out as well. view full answer...
The Magnetic Door Catch Set for RV Cabinets and Drawers # OBE24FR are a simple 1 screw design. You'll want to measure to your desired location for the magnet and strike plate. You can use some painters tape to mark your locations without leaving a mark on your cabinet doors/ drawers. Once you have your locations picked out then simply screw the magnets and strike plates in place using the included screws. view full answer...
You would have to uninstall the slide in order to remove the drawer after using the RV Drawer Travel Locks # 37270765.
They will work with most RV drawers, yes. view full answer...
Please verify the needed measurements for your application and ensure you have purchased the correct item. The RV Cabinet Drawer Slide Socket Set, # 37270735 that we carry is 7/16 and 1 inch width dimensions as per inside dimensions. Please review the linked video as you will see these dimensions as well as more info. view full answer...
The Furrion RV Tankless Water Heater - Gas - Automatic Pilot - 60,000 BTU # FR93FR will be a great tankless replacement for your Atwood GC6AA-10E. The Furrion tankless is 12-5/8" tall so it will fit in your 13" under your drawer. To confirm a fit the other dimensions are 19-3/16" deep x 12-13/16" wide.
You can add a door, Replacement Access Door for Furrion RV Tankless Water Heater - 16" x 16" # FR43FR, as long as you aren't using the drawer above. view full answer...
The body of the Excel RV Tankless On-Demand Water Heater # EX93FR is actually 14.5" tall with the optional louver being an additional 4.5" tall. Because of the vent free design this heater can be placed anywhere besides a bathroom or bedroom so you can place it inside of your kitchen cabinet. It just requires 3" of clearance on the sides and 8" of clearance above.
I actually just watched a video from someone who had theirs installed in a cabinet by cutting the shelf and mounting it to... view full answer...
The closest RV microwave we carry to match the dimensions of your Samsung MR1032UBC microwave is the Greystone Standard RV Microwave w/ Trim Kit # 324-000105. The trim kit will cover the width of your your opening but will not completely cover the 17" height. What you can do to solve that is to cut down a piece of wood to 3" by the length of your cutout hole and stain it to match your cabinets. You can use a pocket hole jig from your local hardware store and a few screws to mount the board... view full answer...
Our storage net selection is pretty limited so the best option we have to cover your 26" x 15" space would be the RV Storage Net - 32" Wide x 8" Tall # OBE99FR. This net comes with a mounting bracket to screw into the cabinet/wall, but would obviously sit a bit past the edge of your space by a few inches on each side. If this wouldn't be a fit for the spacing then you could most likely find some cut-to-fit netting with attachment points at your local hardware store. view full answer...